PENTRON Correct Plus Gebrauchsanweisung Seite 3

hardness. Ideal for Three-in-One impression trays. Recommended with
any wash material in the Correct Plus and Correct Plus Fast Set line.
Auto-Mix Putty (also available in Berry Flavor; not available in

Fast Set): A heavy viscosity material that provides the hydraulic drive of
a hand-mix putty in a convenient auto-mix cartridge. For use in stock,
custom, or triple trays. Recommended with any wash material in the
Correct Plus and Correct Plus Fast Set line.
Putty (also available in Berry flavor; not available in Fast Set): An

easy to mix, heavy viscosity putty with a high end hardness to resist
distortion and provide maximum hydraulic drive of the light body
material. Recommended with any wash material in the Correct Plus and
Correct Plus Fast Set line.
Bite Superfast: This material was designed exclusively for faster bite

registration, with a mousse-like viscosity and high end hardness. When
set, its rigidity facilitates trimming.
Instructions for Use
Auto Mix Cartridges:
1. Select and/or prepare a rigid tray of sufficient size which provides at least
2-3 mm thickness of space for impression material.
2. Apply Correct VPS™ Tray Adhesive to the tray and allow to air dry for 5
minutes. Adhesive should also be used with perforated trays.
3. Load auto mix cartridges into impression guns, both wash and tray
material of choice.
4. Dispose of sealing cap at front end of dual cartridge and extrude 1/4 inch
of material to ensure that equal amounts of material are dispensed.
Discard. Wipe end of cartridge clean. Attach auto-mix tip. Attach an
intraoral tip to the wash material mixing tip.
Note: Mixing Tips are for single patient use only, to prevent cross-
contamination between patients.
5. Dry the field and place cotton rolls.
6. Place your heavy viscosity of choice into impression tray (or see below for
Putty mixing instructions, and place putty into tray). See table below
for specific minimum working times.
7. Remove cotton rolls. Inject syringe mix around tooth preparations. Seat
tray.
8. Retain impression in position until set. See table below for specific
maximum intraoral setting times.
9. Remove the impression from the mouth.
10. Rinse thoroughly under water and disinfect. The impression can be
disinfected by soaking it in Glutaraldehyde or other proper disinfectant
solutions. Follow the manufacturer's directions.
3