Inhaltsverzeichnis
Werbung
Front Panel Audio
Headers
(9-pin HD_AUDIO1)
(see p.1, No. 31)
(9-pin HD_AUDIO_RA1)
(see p.1, No. 30)
1. High Definition Audio supports Jack Sensing, but the panel wire on the chassis
must support HDA to function correctly. Please follow the instructions in our
manual and chassis manual to install your system.
2. If you use an AC'97 audio panel, please install it to the front panel audio header by
the steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don't need to
connect them for the AC'97 audio panel.
E. To activate the front mic, go to the "FrontMic" Tab in the Realtek Control panel
and adjust "Recording Volume".
Chassis/Water Pump Fan
Connectors
(4-pin CHA_FAN1/WP)
(see p.1, No. 20)
(4-pin CHA_FAN2/WP)
(see p.1, No. 26)
(4-pin CHA_FAN3/WP)
(see p.1, No. 32)
CPU Fan Connector
(4-pin CPU_FAN1)
(see p.1, No. 5)
26
These two headers are for
GND
PRESENCE#
MIC_RET
connecting audio devices
OUT_RET
to the front audio panel.
1
* Connect the audio
OUT2_L
J_SENSE
device to either one of the
OUT2_R
MIC2_R
audio connectors.
MIC2_L
This motherboard
GND
FAN_VOLTAGE
provides three 4-Pin water
FAN_SPEED
FAN_SPEED_CONTROL
cooling chassis fan
connectors. If you plan to
1
2
3
4
connect a 3-Pin chassis
water cooler fan, please
connect it to Pin 1-3.
4
3
2
1
This motherboard
provides a 4-Pin CPU fan
GND
(Quiet Fan) connector.
FAN_VOLTAGE
CPU_F
AN_SPEED
If you plan to connect a
FAN_SPEED_CONTROL
3-Pin CPU fan, please
connect it to Pin 1-3.
Werbung
Inhaltsverzeichnis
