Honeywell HW100 Anweisungen Und Warnhinweise Seite 20

Tilt Adjustment
If the welding helmet is too far from or too close to your face, adjust its position using the angle
adjustment plate. Lift the bottom of the angle adjustment plate and position the hole of your
choice over the lock pin to adjust the position of the helmet as shown Figure 3 below
Closer to face
Lift to adjust
Figure 3: Tilt Adjustment
B) Maintenance and Cleaning Instructions
·
Do not use or open the auto-darkening filter if damaged by shock, vibration or pressure.
·
If cover lens is spattered or covered with dirt, it should be replaced immediately.
·
Thoroughly clean all surfaces with soap or mild detergent and warm water.
Do not use strong cleaning solutions. Do NOT submerge ADF cartridge in water.
C) Storing Instructions
Keep in a clean, dry, dust-free environment.
D) ADF Functions
ADF Model
Fixed Shade 10 ADF Model: HW100
AUTO DARKENING SHADE 3/10
XA-1003 HW100
3
4
Tigerhood Book.indb 5
Further from face
1
3/10 CSS 1/1/1/1/379
2
CSS Z87 W3/10
2
3
4
GB_AU_NZ-5
3/14/13 4:36 PM