Herunterladen Diese Seite drucken

HANSGROHE Uno 14824000 Montageanleitung Seite 7

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 5
Attention! The fitting must be installed, flushed and
tested after the valid norms.
Assembly
1.
Flush through the supply pipes.
2.
Place the mixer including the sealing washer in
position on the sink.
3.
Slip the plastic washer, the slide washer, the
metall washer and collar nut over the hose
and threaded base and tighten the collar nut
by hand. If there is not enough space, please
use only the slide washer and the metall without
the plastic washer.
4.
Tighten screws.
5.
Connect the connecting hose to the angle valves;
cold right - hot left.
Large differences in pressure between the hot and
cold water supply should be balanced.
Technical Data
Operating pressure:
Recommended operating
pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.: 65° C
Rate of flow:
Fault
Insufficient water
Mixer stiff
Mixer dripping
Water escaping in area of swivel
spout
Water escaping at the threaded
base
Hot water temperature too low
English
max. 10 bars
1 - 5 bars
16 bars
max. 80° C
13 l/min 3 bars
Cause
- Aerator calcified, dirty
- Cartridge defective, calcified
- Cartridge defective
- O-Ring defective
- connection hoses not completely
screwed into basic body
- O-Rings defective by the
connection hoses
- Hot water limiter incorrectly set
Hansgrohe single lever mixers can be used together
with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 1.5 bars.
To adjust the hot water limiter on single lever mixers,
please see page 16.
No adjustment is necessary when using a continuous
flow water heater.
Spare parts (see page 3)
1
lever head Allegra Uno
1.1 screw cover
2
flange
3
nut
4
cartridge cpl.
5
aerator cpl. (10)
6
fixation cpl.
7
connection hose 600 mm
8
spout cpl. Allegra Uno
9
sealing set
10 ELASTOP stop unit
XXX = Colors
000 chrome plated
750 alux
Remedy
- Clean aerator, replace as
necessary
- Exchange cartridge
- Exchange cartridge
- Exchange O-Ring
- Tighten connection hoses by
hand
- Exchange O-Ring
- Set hot water limiter
14896X X X
96338000
96468XXX
96461000
92730000
13913000
95049000
14099000
96514X X X
92646000
94849000
7

Werbung

loading

Diese Anleitung auch für:

Uno 14850 serieUno 14814000Uno 14855 serie