Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 15

CAUTIONS

!
1- Place the unit on a solid base at adequate height, in an adequate area for its use. Make sure
that the location does not allow the unit or its contents to accidentally fall and it is strong enough
to support the weight of the unit.
2- Do not place anything on top of the ice-cube making machine; this could damage the Ice-cream
making machine or cause personal injuries.
3- When you install the machine for operation, make sure that it is not connected to the mains
supply. Otherwise, it may cause personal injury.
4- To avoid damaging the ice-cube making machine or personal injury, always start the machine
with content inside.
5- The unit is not waterproof. For safe and adequate operation, place the unit inside where the
room temperature is at least 21ºC (70ºF) and up to 29ºC (85ºF).
6- Do not place the ice-cube making machine in an area exposed to excessive temperatures or
to hotplate or deep-fryer grease, etc. Excessive temperature can cause damage to the unit.
7- Do not place the ice-cube making machine in an area without ventilation at the front of the
machine.
8- During transport, do not incline the ice-cube making machine in excess of 45º as there is dan-
ger of harming the compressor.
9- To avoid problems with the cold compressor, do not switch on or off the device until at least 5
minutes have passed between the starting and the switching off.
10- Before using the ice making machine for the first time, wait 2 hours after its installation and
keep the front lid open for at least 2 hours.
11- Normally the compressor and the condenser reach temperatures between 70ºC and 90ºC.
The surrounding may get very hot, please, do not touch them.
12- Due to the fast freezing, the ice-cubes can appear to have a "cloudy" colour. Air is trapped in
the water and will not affect the quality or taste of the ice.
13- When it is not being used, please open the drawer at least 2 cm to allow air circulation and
avoid rusting of the metallic components.
14- ONLY fill with bottled or good quality water. (Do not fill with fruit juice or other types of drinks).
23

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis