Power Supply - Nauta miniK10 Bedienungsanleitung

0 - Reset factory settings
With this function all factory settings are reset. The user code is also deleted, and the lock can only be
opened with the master code. The master code remains unchanged and is not reset to the factory code.
1 - Lock functions
Here you can set the desired lock function. For an explanation of the various functions, see chapter 1.2
lock functions.
2 - Sound
It is possible to disable all sounds. But a few sounds will remain active as warning signals.
3 - Manipulate blocking
You can set it so that the lock blocks automatically for approximately five minutes after a code has been
entered incorrectly three consecutive times. The keypad is then unresponsive for five minutes.
4 - Remove user
With this function the pre-programmed user code is set back to the factory code (1-0-1-0).
5 - Setting the Service code
With this function you can set a service code for unlocking in an emergency. When first using the lock
you should first activate the service code.
6 - Locking with a code
If the lock is in single user mode, the lock will close without asking for an access code. If you prefer that
the lock will only close with an access code, you can use this function to set that option.
7 - Warning
If the door is open for longer than a minute, you will hear 8 beeps every 5 seconds.
8 - Service code emergency unlocking - reset
If an emergency unlocking with a service code has occurred, the access code will automatically reset to
its factory code (1-0-1-0).
9 - Service code emergency unlocking - usage blocking
If emergency unlocking been enabled with a service code has occurred, the lock cannot be closed with
that service code afterwards. This ensures that the service code is only used for emergency unlocking.

6. Power supply

As soon as the battery is almost empty (and the voltage is too low), the red light will flash five times
following each action. This is a sign that the battery needs to be replaced.
Use a CR2450 3V button cell battery for the lock. Unscrew the cover on the back of the lock.
Battery consumption will be higher if programs 2, 3 and 7 are active.
21