Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTALLATION
WARNING! Risk of injury caused by falling objects
Devices in overhead installations may cause severe injuries when crashing down. Make sure
that the device is installed securely and cannot fall down. The installation must be carried out by a
specialist who is familiar with the hazards and the relevant regulations.
The device may be placed via the mounting bracket on a lighting stand or fastened to a truss or similar
rigging structure. The device must never be fixed swinging freely in the room.
1
The rigging structure must support at least 10 times the weight of all fixtures to be installed on it.
2
Block access below the work area and work from a stable platform when installing the device.
3
Use rigging hardware that is compatible with the structure and capable of bearing the weight of the
device. Please refer to the "Accessories" section for a list of suitable rigging hardware.
4
Secure the device with a safety bond or other secondary attachment. This secondary safety attachment
must be sufficiently dimensioned in accordance with the latest industrial safety regulations and
constructed in a way that no part of the installation can fall down if the main attachment fails. Use the
hole on the rear of the device for fixation of the safety rope. Fasten the safety rope in such a way that, in
the event of a fall, the maximum drop distance of the device will not exceed 20 cm
5
To align the device, release the fixation screws at the mounting bracket, adjust the desired inclination
angle and tighten the fixation screws.
6
After installation, the device requires inspections periodically to prevent the possibility of corrosion,
deformation and looseness.
Installation on a lighting stand
Please note: All devices, lighting effects and crossbeams attached on a stand must be secured with a
secondary attachment!
1
Attach an appropriate adapter or TV-adapter to the top end of the stand and fasten it with the fixation
screw.
2
Attach the mounting bracket of the theater spot onto the TV-adapter and tighten the fixation screw.
3
The given carrying capacity of the stand must not be exceeded. Please consult the appropriate user
manual for further information.
4
To align the device, release the fixation screws at the mounting bracket, adjust the desired inclination
angle and tighten the fixation screws.
5
After installation, the device requires inspections periodically to prevent the possibility of corrosion,
deformation and looseness.
INSTALLING/REPLACING THE ILLUMINANT
DANGER! Electric shock caused by high voltages
Within the device there are areas where high voltages may be present. Always disconnect the
device from the mains socket prior to installing or replacing a lamp.
WARNING! Risk of burns at the surface and in case of inappropriate handling of the
illuminant
The device and the illuminant become very hot during operation. Let the device cool down for at
least 5 minutes before replacing the illuminant.
14/16
00047599, Version 1.1
Werbung
Inhaltsverzeichnis
