Assembly; Setting The Sitting Position - DELTA-SPORT IAN 110411 Gebrauchsanweisung

WARNING!
Risk of suffocation for children! Do not al-
low children to play with packaging materi-
al or the article without supervision .
• Keep the article away from children .
They could try to stand on it or pull them-
selves up on it and could thus tip the
stool .
• Only use the article in accordance with
the intended use .
• The article may only be used by persons
who are familiar with the safety notes .
• The article has a maximum load capacity
of 120kg .
• Durability of plastic parts: 5 years maxi-
mum . Only use the article at the longest
until the use-by date on the type plate .
• Inspect the article for damage or wear
before each use . Check that all screw
connections are secure before each use!
The article may only be used if in perfect
condition! Do not use the article if it has
visible or suspected damage!
• Only use the article if the temperature
of the surfaces is safe . The surface of the
article can achieve temperatures that are
harmful to health through hot water,
direct sunlight, sauna conditions, extreme
cold etc .
• Risk of slipping! Ensure that the article
is standing securely before each use and
make sure that there is an anti-slip surface
in place outside and inside the shower
tray .
• Risk of tipping! Sit only in the centre of
the seat . Do not stand on the article .
Sit upright on the article .
• Do not grip into the height adjustment
holes and make sure you do not trap any
body part .
Take care not to cause
damage to property!
• Do not use corrosive or abrasive clean-
ing materials .
• We do not accept any liability for dam-
age of any kind of damage to the show-
er tray .
• Check the shower stool every 3 months
for the secure and correct position of
the screws and all other connections
and tighten where necessary . If in doubt
please contact the product hotline .

Assembly

Attach both seat tubes (1, 2) to the seat
(3) .
Use a screw (4) and the rounded washer
(5) for the centre and the other four screws
(4) and the straight washers (6) for the
corners . Tighten the screws (fig . B, C) .
Insert the leg tubes with the rubber feet (7)
to the seat tubes (fig . D) .
Setting the sitting
position
Caution!
• Please be careful not to trap any part of
the body in the drilled holes .
• Do not use the article if the button to set
the seat height is not in place in one of
the drill holes!
• Set all feet to the same height in order
to avoid tipping of the article!
Press the buttons on the seat pipes and pull
the feet pipes until the desired height is
reached . The buttons must click visibly and
audibly into place in the drill holes (fig . E) .
Set all the foot pipes to the same height .
If necessary, turn the rubber feet so that
they are flat and secure on the floor to give
the stool a stable position (fig . F) .
GB 11