ring SmartCharge RSC608 Bedienungsanleitung Seite 5

5
Connection
1. Ensure AC mains plug is not connected to the AC mains supply
2. For batteries inside the vehicle:
3. The polarity check LED illuminates if the charger is connected to the battery incorrectly. i.e. the red (+) clip connected to
4. Connect mains plug to the AC mains supply and switch on.
5. After charging, disconnect the battery charger from the supply mains. Then remove the chassis connection and
6
Operation - Battery Charging
Select the charging mode required
Normal Battery
RSC608/RESC608
RSC612/RESC612
* Default charging modes
1. Select the battery / vehicle type you are charging:
Standard vehicle – using traditional lead acid battery types (14.4v applied)
Start / Stop vehicle – using modern AGM battery types (14.6v applied)
2. Press the navigation arrows to select the battery charging icon and press SET.
SET
Battery Charging
3. Press the navigation arrows to select the required charging mode and press SET.
Charging &
maintenance modes Maintenance charge
Pressing EXIT at any stage takes you to the first stage of the menu process.
Repair Winter charge
• Attach the red (+) battery clip to the red (+) terminal on the battery
• Attach the black (-) battery clip to a bolt or bracket on the engine block, away from the battery and fuel lines
For batteries outside the vehicle:
• Attach the red (+) battery clip to the red (+) terminal on the battery
• Attach the black (-) battery clip to the black (-) terminal on the battery
the black (-) battery terminal. Ensure connection is correct and the 'Polarity Check' LED is not illuminated
then the battery connection.
Maintainance
Charging Charging
* (Up to 8A) (0.8A)
* (Up to 12A) (0.8A)
Winter Battery
Charging Recondition
5
Start/Stop Standard
Vehicles Vehicles
*
*