Assign Calls - Gewiss ANTAS Programmierhandbuch

Programming Manual-System Programming

ASSIGN CALLS

y
Manual programming is possible only if the system is composed of a single ANTAS entry panel. In the instan-
ce where the KARALIS entry panel is present, you must initiate manual programming of system ANTAS
as described below.
In such a case, it is not necessary to execute programming via the GW19351 power supplier; the other
KARALIS entry panels will be programmed as described in the relative manual.
Main Menu
General Settings
Names and Calls
Assign Calls
Codes
ESC
Assign Calls
IT
Hold on
EN
ESC
Assign Calls
Press
DE
to continue
FR
ESC
Assign Calls
ES
Set the receiver
in programming
mode
ESC
PT
a
beep
b
46
Using this menu, you can assign each internal extension the corresponding call code.
To enter the programming mode, use the key
Once you have entered the programming mode, the system will be-
gin a self-learning phase.
Program. impianto
Lingua
When finished, the LEDs on the entry panel will light up as shown
Attendere
in the figure to the side.
To continue programming, press the key
ESC
Program. impianto
Lingua When the screen shown to the side appears, follow the procedure
Attendere
described below in order to assign the call code to the internal ex-
ABC DEF
tension.
GHI JKL MNO
ESC
PQRS TUV WXYZ
Program. impianto
Lingua
Attendere
Lift the receiver (if present) of the extension that you want to pro-
DEF
ABC
gramme and press the door lock release
GHI MNO
JKL
ESC
PQRS TUV
WXYZ
To assign the call code, select the desired group using the arrows
Select Group
Mario Rossi
ABC DEF
Gianni Verdi
An acoustic signal will confirm that the programming was success-
Antonio Bianchi GHI JKL MNO
ful b.
Luca Viola
PQRS TUV WXYZ
ESC
.
and confirm by pressing
.
and Aux 2 keys a.
.