Setting Values; Programming With The Software Gw19373 - Gewiss ANTAS Programmierhandbuch

Setting values

Name
ANTAS_
ESC
Backlight On
By touch
✓ Always on
By Command
ESC
✓
Date format
✓ DD/MM/YYYY
MM/DD/YYYY
YYYY/MM/DD
YYYY/DD/MM
ESC
Confirmation for execution of a function
Reset
Press
to confirm
ESC

PROGRAMMING WITH THE SOFTWARE GW19373

If the entry panel has been programmed using the GW19373 software, for safety reasons,
only some parameters are modifiable.
In all the other cases, the symbol shown to the side will appear on the display.
ESC
In all the screens in which you must enter alphanumeric characters,
Call Code
the window opens displaying the current value with the cursor po-
sitioned on the last character.
By pressing the key you can delete the entered values while po-
4567_
sitioning with the cursor again on the last character.
You can exit these screens by confirming with
Press
ESC
seconds).
Keypad
Using the keys you can increase, decrease or select the values
5 requested in the screen.
(2-15)
Press
seconds).
ESC
✓
Keypad
The last selection made is marked with the "tick" symbol (
left of one of the possible choices.
5
Once the selection has been made, the setting made is marked with
(2-15)
the "tick" symbol (
ESC
Delete
You can exit these screens by confirm/contine with
exit without saving by pressing ESC.
Press
to confirm
ESC
Programming Manual-Using the Programming Keys
to confirm. Press ESC to exit or wait for the time-out (10
to confirm. Press ESC to exit or wait for the time-out (10
) on the top right-hand corner of the screen.
✓
.
IT
) to the
✓
EN
DE
or you can
FR
ES
PT
35