Replacing The Battery; Replacing The Pen Nib - Silvercrest SGT 10.6 A2 Bedienungsanleitung Und Serviceinformationen

Replacing the battery

To replace the battery proceed as follows:
Remember to protect the environment. Used batteries should not be disposed of in domestic waste.
They must be taken to a collection point for old batteries.

Replacing the pen nib

To replace the pen nib proceed as follows:
SilverCrest graphics tablet SGT 10.6 A2
1. Remove the cap.
2. Push the cover upwards slightly and lift it
off.
Do not push the cover too far
upwards, as the tabs at the front could
otherwise break off.
3. Replace the used battery with a new
battery (1.5 V, type AAA ). The positive
pole (+) must always point towards the
open end of the pen.
Always ensure correct polarity of the
battery!
4. Place the tabs of the cover into the front of
the bottom section and carefully push
down until the cover snaps into place on
the bottom section. Do not use any force.
5. Replace the pen cap.
1. Grip the nib (O) with the nib extractor (Q)
and pull the nib out of the pen.
2. Push a new nib (O) as far as possible into
the pen.
English - 95