YATO YT-82170 Originalanleitung Seite 16

GB
observed during inspections or during work are a signal to have repairs done in a service point, for which it is required to contact
the manufacturer. Once work has been concluded, the enclosure, the ventilation slots, the switches the additional handle and the
guards must be cleaned, for example with air jet (whose pressure must not exceed 0.3 MPa), with a brush or a dry cloth, without
any chemicals or cleaning agents. Do not use any sharp objects to clean the tool. It is required to dismantle the circular saw and
clean the internal section of the guards, the fixture of the circular saw and the saw itself from dust and other contamination gener-
ated during work. The handles, handwheels and other adjustment elements should be cleaned with a dry and clean cloth.
O R I G I N A L I N S T R U C T I O N S
16