Specifications - Makita TD126D Betriebsanleitung

ENGLISH
(Original instructions)
1 Red indicator
2 Button
3 Battery cartridge
4 Switch trigger
5 Lamp
6 Reversing switch lever

SPECIFICATIONS

Capacities
No load speed (min
Impacts per minute
Overall length
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heaviest combi-
nation, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of resi-
dence.
WARNING: Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Intended use
The tool is intended for screw driving in wood, metal and
plastic.
General Power Tool Safety Warnings
WARNING Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
4
Explanation of general view
7 Bit
8 Sleeve
9 Bit-piece
10 Groove
11 Hook
12 Screw
Model
Machine screw
Standard bolt
High tensile bolt
–1
)
Net weight
D.C. 14.4 V Model
D.C. 18 V Model
TD126D
0 – 2,400
1.4 kg
D.C. 14.4 V
ENE033-1
CORDLESS IMPACT DRIVER SAFETY
WARNINGS
1. Hold the power tool by insulated gripping
GEA010-2
surfaces, when performing an operation where
the fastener
Fasteners contacting a "live" wire may make
exposed metal parts of the power tool "live" and
could give the operator an electric shock.
2. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
3. Hold the tool firmly.
4. Wear ear protectors.
5. Do not
immediately after operation. They may be
extremely hot and could burn your skin.
6. Keep hands away from rotating parts.
7. Use auxiliary handle(s), if supplied with the tool.
Loss of control can cause personal injury.
13 Vent
14 Standard bolt
15 Fastening torque
16 Proper fastening torque
17 Fastening time
18 High tensile bolt
4 mm – 8 mm
5 mm – 14 mm
5 mm – 12 mm
0 – 3,000
173 mm
D.C. 18 V
BL1413G / BL1415G
BL1813G / BL1815G
DC18WA
may contact
touch the bit or
TD127D
0 – 2,300
1.5 kg
GEB137-1
hidden wiring.
the workpiece