Introduction
We are pleased you decided in favour of this superior coffee grinder and would like to thank
you for your confi dence. Its easy operation and wide range of applications will certainly fi ll you
with enthusiasm as well. To make sure you can enjoy using this appliance for a long time,
please read through the following notes carefully and observe them. Keep this instruction manual safely.
Hand out all documents to third persons when passing on the appliance. Thank you very much.
Intended use
The appliance is designed to be used in the household and similar areas, like for example:
- staff kitchens in shops, offi ces and other small commercial areas,
- agricultural holdings,
- by guests in hotels, motels and further similar living environments,
- breakfast pensions.
Other uses or modifi cations of the appliance are not intended and may constitute considerable risks of
accident. For damage arising from any improper use, the manufacturer does not assume liability.
The appliance is designed for grinding whole, roasted coffee/espresso beans. It can also be used for
chopping dried or fresh herbs, dry spices such as peppercorns, coriander, caraway seeds, chili peppers etc.
and shelled nuts. The appliance is not designed for commercial use.
Technical data
Only connect the appliance to an isolated ground receptacle installed according to regulations.
The rated voltage must comply with the details on the rating label. Only connect to alternating current.
Nominal voltage:
Nominal power:
Max. continuous operation time:
Protection class:
Filling quantity of the containers:
Scope of supply
Check the scope of supply for completeness as well as for perfect condition of the product and all
components (see product description page 2) immediately after unpacking.
Packing material
Do not simply throw the packing material away but recycle it.
Deliver paper, cardboard and corrugated cardboard packing to collecting facilities.
Also put plastic packing material and foils into the intended collecting basins.
12
GB
220 – 240 V~ 50/60 Hz
200 W
30 seconds under full load
II
max. 50 g (note the marking)
In the examples for the plastic marking
PE stands for polyethylene, the code fi gure 02 for PE-HD,
04 for PE-LD, PP for polypropylene, PS for polystyrene.