Inhaltsverzeichnis
Werbung
Be careful when using sharp blades.
Avoid any contact with sharp parts of the device while moving.
Incorrectly assembled device may cause fire, electric shock or other injury.
Maximum allowable continuous operating time is 30 sec. Turn off the device and allow the engine cool down for 1 min before continuing. After 4 rounds allow the engine cool down for 15
min before continuing.
BEFORE THE FIRST USE
Unpack the appliance and remove all packaging materials and labels.
Clean the motor block with a damp cloth, clean the accessories in soapy water rinse thoroughly and dry.
Set proper accessory, aligning arrow on the accessory and an open lock icon on the handle and turn it clockwise up to the stop.
USING THE DEVICE
SPEED SELECTION
Press speed mode button I to start operating.
Then use the speed controller to increase or decrease the speed gradually.
Choose speed mode, depending on the products. Start using low speed, gradually moving to higher.
CAUTION: speed controller operates with pressed button I only.
To use maximum speed, press speed mode button II.
I.
USING BLENDER
Set blender accessory.
Place the accessory in the cup with the product, hold the handle.
Connect the device to the mains, select the proper speed.
Move blender in the cup in a circular motion for proper grinding.
Don‟t allow any liquid reaching device handle.
In case cutting blades are blocked, unplug the appliance from the mains.
After use, remove blender from the mains and disconnect the accessory.
II. USING WHISK
Connect upper and metal parts of the whisk.
Fix handle on the upper part of the whisk.
Place product inside of the cup.
Turn device on. Choose proper speed.
After use plug device out from the mains and disconnect the whisk.
III. USING CHOPPER
Fix chopper blades inside of the chopper cup, add products.
Place the cover and motor block and fix it tight.
Connect the device to the mains, choose proper speed.
After use plug device out from the mains and disconnect the chopper.
7
Werbung
Inhaltsverzeichnis
