Attaching.the.pioneer.display.and.television - Pioneer KURO KRP-TS02 Bedienungsanleitung

Attaching the Pioneer Display and Television
The.weight.of.a.Pioneer.display.and.television.is.
about.0.kg.(.lbs),.they.have.no.depth,.and.are.
unstable..Therefore,.at.least.two.people.must.
assemble.and.install.them.
•. Be.sure.to.install.it.on.a.flat.stable.location.
•. Insert.the.screws.in.the.holes.vertically.and.securely.tighten.
•. Place.a.sheet.or.other.material.under.the.display.to.prevent.
scratches.or.damage.to.it.
•. After.manually.turning.the.screw.lightly.two.or.three.times,.
tighten.it.with.a.screw-driver.
1
. Attaching.the.Pioneer.display.and.
television.to.the.stand.
Lay the Pioneer display and television down flat. Align the
stand supports with the Pioneer display and television
stand slots, and slowly insert the supports horizontally.
Please ensure that the stand supports do not come into
contact with anything other than the Pioneer display and
television stand slots. Contact with any other area may
result in scratching or deformation of the display's rear
side or terminals.
When.laying.down.the.Pioneer.display.and.television,.be.
careful.so.as.to.not.scratch.or.damage.it.
2
. Securing.the.Pioneer.display.and.television.
with.Installation.screws.
Secure the parts marked with the arrows (holes marked
"T") using a Phillips screwdriver.
[PDP-LX00./.PDP-LX00H./.PDP-LX0A./.PDP-
C0A./.PRO-101FD]
KRP-TS02 / PDK-TS33A / PDK-TS33
Upper .....................Installation screw
Bottom ...................Installation screw
[KRP-00A./.KRP-00M]
KRP-TS02
Upper .....................Installation screw
Bottom ...................Installation screw
(M8 × 40 mm: black)
➁
➃ (M8 × 15 mm: black)
(M8 × 23 mm: black)
➂
(M8 × 15 mm: black)
➃
1
En