Assembling.the.stand; Assembly Procedure - Pioneer KURO KRP-TS02 Bedienungsanleitung

Assembling the Stand

Assembly Procedure

1
. Turn.the.base.cover.over.so.the.underside.is.
facing.up.
2
. Insert.the.stand.pipes.into.the.base.cover.
• Insert stand pipe (R) into the side marked "R" and
stand pipe (L) into the side marked "L".
• Ensure that the open sides of the stand pipes face
inward. Insert the stand pipes, making sure to match
them to the raised portion of the base cover.
3
. Tighten.the.screws. ➀
to.stabilize.the.stand.pipes.
•.
Assemble.the.stand.with.a.soft.sheet.placed.under.the.base.
cover..If.a.sheet.is.not.laid.before.assembly,.the.front.surface.
of.the.base.cover.may.be.scratched.
•.
Please.take.care.when.installing.stand.pipes.(L).and.(R).to.
ensure.that.they.are.in.the.correct.positions..Mistakenly.
installing.the.stand.pipes.may.damage.the.stand.
.(.mm.×.10.mm:.silver).
4
. After.assembling.the.stand,.attach.the.falling.
prevention.metal.fittings.with.the.installation.
screws. .(M.×..mm:.black).
➄
Be.sure.not.to.attach.the.falling.prevention.metal.fittings.in.the.
reverse.position.
11
En