Motostar LIVI-LS2 Allgemeine Hinweise Seite 4

Function of terminals ��
BUS-line input
NO
Relay-switch 1 normally open
C1
Relay-switch 1 contact
NC
Relay-switch 1 normally closed
NO
Relay-switch 2 normally open
C2
Relay-switch 2 contact
NC
Relay-switch 2 normally closed
Function of the DIP-SWITCHES ��
DIP-SWITCH 1 - It establishes which function is associated to re-
lay-switch 1
OFF Open-door control
ON Aux 1 control
DIP-SWITCH 2 - This establishes the adjusting range of the TIMER po-
tentiometer for the relay-switches' operating time
OFF The range is from 1 to 16 seconds
ON Range of 30 seconds to 8 minutes, with 30 seconds intervals.
DIP-SWITCHES 3 and 4 - These lets you select the modules manu-
al-programming mode. Please read the "Manual Programming" chapter
DIP-SWITCH 5 - It enables the manual programming of relay-switch 1
OFF Disabled for programming
FG00834M07 - ver. 1 - 09/2017
DIP-SWITCH 5 - It enables the manual programming of relay-switch 1
ON Enabled for programming
DIP-SWITCH 6 - It enables the manual programming of relay-switch 2
OFF Disabled for programming
ON Enabled for programming
DIP-SWITCH 7 - This lets you select which relay-switch to schedule bu
applying the set by DIP-SWITCH 2 modes.
OFF Relay-switch 1 is scheduled
ON Relay-switch 2 is scheduled
DIP-SWITCH 8 - This is for choosing the module's programming modes
OFF Manually programmable
ON Programmable by software
NOTE. The factory setting require that all DIP-SWITCHES be in the OFF
position.
When all the DIP-SWITCHES are set to OFF, the relay-switches work in
the following modes:
the Open-door button on the indoor receiver activates relay-switch
1 for a set time between 1 and 16 seconds. You can set this time on
the TIMER.
Whereas the Aux 2 button on the indoor receiver activates relay-switch
2 for 1 second.
code 12345 typedonan entry panel's keypad, activates relay-switch 1
for a variable time between 1 and 16 seconds. You can set this time on
the TIMER.