System Lay-Out; Technical Characteristics - Eco 24/E Wichtige Sicherheitshinweise

SYSTEM LAY-OUT

—
‚
š
1 - ECO 24/E operator
2 - Tuned aerial
3 - Flashing lamp
4 - Key selector
5 - Photoelectric cells (external)
6-1624090 rev.05 01/07/2010
˜
™
š ™
‚
1
T
ECHNICAL CHARACTERISTICS
ECO 24/E is a linear operator suitable for opening gates with a
leaf length of up to 2 meters and a weight of up to 250 kg (Fig. 1).
The ECO 24/E operators use built-in mechanical stoppers, thus
avoiding the need for electrical limit switches.
ECO 24/E is already equipped with a built-in Encoder to sense
obstacle while closing or opening. The Encoder permits the
proper stop at the end of travel for opening and closing.
On reaching the stopper, ECO 24/E model stops automatically
following the command gived by the built-in Encoder.
N.B.: When installing ECO 24/E it is advisable to instal an
electrical lock to ensure an efficient locking of the gate.
TECHNICAL
DATA
Max. leaf length
Max. leaf weight
Max. travel
Average opening time
Operating speed
Power supply
Nominal Motor capacity
Max Motor capacity (blocked)
Nominal Power absorbed
Max Power absorbed (blocked)
Nominal Thrust force
Max Thrust force (blocked)
Normative cycles
Daily operations suggested
Service
Guaranteed consecutive cycles
Weight of electroreducer
Noise
Operating Temperature
Protection
** With incorporated mechanical stop that cuts in during opening. - If the
mechanical stop is used during closing (optional), the maximum
travel is reduced by 30 mm.
ECO 24/E
m. 2
kg 250
mm 343**
s. 14
m/sec. 0,0134
24Vdc
W 12
W 89
A 0,88
A 3,72
N 1000
N 1500
n° ∞ - 14s/2s
n° 60
80%
n° 60/14s
kg 5
db <70
°C -30 ÷ +55°C
IP 44
2
Measurements in mm
G G
B B