Operations; Getting Ready - Bissell VAC & STEAM Bedienungsanleitung

Operations

Getting Ready

The mop pad may have already come attached
to the mop pad tray on the foot of the unit. If
not, please follow step 1 below.
For Microfibre Mop pads, please follow
these steps:
1. Attach mop pad.
a. Step on foot release for mop pad tray
and lift unit off tray.
b. Some units may come with freshening
discs. Add Freshening Disc in the mesh
pocket in the mop pad. Use the whole
disc for a refreshing scent or cut in half
for a lighter scent.
c. Wrap mop pad around the bottom of
the tray, making sure the gray stitching is
in the front and the quick release tab is in
the back.
d. Put the mop pad tray back down on
the floor and set the unit back on top. It
will click into place.
2. Fill the water tank.
a. On the back of the unit, open the Easy
Fill opening of the water tank and use the
included water cup to fill the water tank with
water. Don't overfill or water may spill from
the tank. For best results, water should be at
room temperature.
b. Close the Easy Fill opening.
c. The water tank holds 384 mL and will last
approximately 15 minutes depending on the
amount of the steam used during cleaning.
3. Pull and twist the Quick Release cord wrap
clockwise to unwrap the power cord completely
and plug into an outlet as described on the
Important Safety Instructions on page 2.
NOTE: Upon the first use of the Vac & Steam™
or first use after refilling the water tank, the
pump may make a 'knocking' sound. This is
normal and could last up to 30 seconds.
6
www.BISSELL.com
» Use of distilled water is
recommended to prolong
the life of your hard floor
cleaner.
Microfibre Mop Pad
1a.
1b.
WARNING
Do not operate appliance with damp or wet
filters or without all filters in place.
WARNING
Tinted plates on foot may get hot while
steam mop is in use. Do not touch while hot.
WARNING
Never put descaling, alcoholic, or detergent products
into the steam cleaner, as this may damage it or make
it unsafe for use.
Tip
1c.
2.