Maintenance & Care - Bissell VAC & STEAM Bedienungsanleitung

Maintenance & Care
Removing All Mop Pads
1. Unplug hard floor cleaner from electrical outlet.
2. Step on foot release for mop pad tray and
lift unit off tray.
3. Carefully remove mop pad from the mop
pad tray using the Quick Release Tab. The
mop pad and tray may be hot.
4. Put the mop pad tray back down on the
floor and set the unit back on top. It will click
into place.
5. The microfibre mop pad can be machine
washed in warm water. Use only liquid
detergents. Do not use fabric softeners
or bleach. For best results, air dry.
Empty Dirt Tank
The dirt tank needs to be emptied when the dirt
reaches the 'Full' line on the side of the tank.
1. Unplug hard floor cleaner from electrical outlet.
2. Remove the Easy Empty dirt tank from the
unit by moving the lock button on the front of
the unit to the left.
3. Press the bottom lid release button on the
back of the dirt tank to empty dirt.
4. The dirt tank also has a built in Drop-IT
system for easy debris emptying.
a. In the middle of the vacuum filter
attached to the top of the dirt tank
locate the color rod
b. Pull the rod up and lock the rod in
place by turning it clockwise
c. Push down on the lever to force out
stuck debris
d. When done, rotate the color rod
counter-clock wise and push it down to
return it to its original position
5. Close the bottom lid and mount the Easy
Empty dirt tank back on the vacuum base
and push the lock button to the right until it is
centered on the front of the unit.
NOTE: The dirt tank may be washed in warm
water with a mild detergent. Make sure it is
completely dry before replacing.
8
www.BISSELL.com
WARNING
To reduce the risk of electric shock, turn power switch off
and disconnect polarized plug from electrical outlet before
performing maintenance or troubleshooting checks.
CAUTION
Upright storage of the cleaner with a wet mop pad may
result in the formation of white marks on your floor. To
remove the white marks, clean area with vinegar.
2.
2. 3.
4b. 4c.