Novellini 40465ELE-30 Betriebsanweisung Seite 21

Time adjustment menu:
From the main menu, press and hold the time button on the
display until the time adjustment sub-menu appears.
16 Press the + and - buttons to adjust the hours.
17 Press the + and - buttons to adjust the minutes.
18 Press to confirm and return to the main menu.
16
17
18
Draining:
In order to empty the pipes, the bath is equipped with a drainage
system.
• After a hydromassage, about 30 minutes after the bath has
been emptied, the blower is automatically activated (for about
a minute) to expel the water that has remained in the pipes.
• When the bath has been used without a hydromassage,
drainage will need to be performed manually.
To do so, go to the hydromassage menu, and press and hold
button 6 for 4-5 seconds until the blower comes on. The blower
will stop automatically after 1 minute.
Alarm:
19 Communication failure between the central unit and the
remote control. Check that the power unit is switched on.
If it is not, contact the service centre.
19
12:33
12:33
12:33
h 16
m 17
12:33
Description of the ON-OFF remote control:
21
20
Remote control functions:
The hydromassage can be started by pressing button 20 on the
remote control. If there is enough water in the bath, the pump
will start.
Otherwise, the LED on the remote control will flash for about 10
seconds.
Once the water level has been topped up, the hydromassage will
start automatically. To turn off the hydromassage, press 20.
Controlling the massage intensity:
The jet coming out from the nozzles is a WATER/AIR mix, that is
formed inside the nozzles by means of a suction effect known as
the "VENTURI EFFECT".
Press and hold button 21 to adjust the intensity of the Whirlpool
massage. Simply release the button to apply the new setting.
-21-
ENGLISH