Novellini 40465ELE-30 Betriebsanweisung Seite 20

ENGLISH
10
Whirlpool sub-menu:
Repeatedly press button 5 to select the Whirlpool function.
Manual Whirlpool function:
Press and hold button 11 to adjust the intensity of the Whirlpool
massage. Simply release the button to apply the new setting.
10'
Automatic Whirlpool function:
The massage intensity is varied to create a pleasant modulating
effect.
You can return from the hydromassage menu to the main menu
using button 12.
10'
12
Airpool sub-menu:
Repeatedly press button 13 to select the Airpool function.
10'
Disinfection menu:
Press button 2 on the main menu to access the disinfection
menu.
To start disinfection, once the bath has been cleaned, fill the
12:33
11
12:33
12:33
12:33
13
12:33
D
bath with clean water up to the level used during normal use.
Fill the disinfectant tank (only on first use or when subsequently
required), and press button 14 to release the system.
Then use button 15 to start the disinfection process.
The pump will activate and the disinfectant soon begins to
circulate. After 4 minutes, the pump stops for about 20 minutes
and then restarts for a further minute.
After this time, a symbol appears on the display to indicate that
the bath is ready to be emptied.
If the image below is displayed at the beginning of the
disinfection process, and disinfection does not start, adjust the
level of disinfectant.
Another reason for the disinfection process to fail to start may
be that there is insufficient water in the bath. In this case, the
image below will be displayed.
Top up the bath with water to restart the disinfection process.
Do not bathe in or use the water that has been used for
disinfection.
If the disinfection process is interrupted for any reason, the
disinfection symbol on the main menu lights up to warn that
disinfection has not been completed.
To cancel this warning, carry out a complete disinfection cycle
afresh.
-20-
12:33
14
15
12:33
12:33