Starting Your Filter - Aqua One Nautilus 600 Aufbauanleitungen

Starting Your Filter

Method 1
Note: Your aquarium must be filled with water to prime
your filter. Ensure the tap is in the ON position by
pressing the locking lever down (Fig 1). Once the filter
is running double check the fittings and seals for water
tightness. Fig 1
1. The Primer for your canister filter is located at the
top of the head unit. Press the Primer down all the way,
then release. Continue to pump the Primer until the
water flows down the inlet tube and begins to fill the
canister.
2. Stop pumping and allow the canister to fill with
water.
3. The filter is primed when the intake pipe and canister
are completely filled and the water starts to travel up
the outlet tube. Now the canister filter is ready to be
plugged in.
Method 2
1. Temporarily detach the outlet from the tubing and
create a siphon by sucking on the tube. Once the
siphon begins, lower the outlet tube into a bucket.
2. Wait until the canister is completely full of water. You
will know this when the water starts to flow into the
bucket.
3. Place your thumb over the open end of the tubing
and affix the outlet pipe to your aquarium.
4. Now the canister filter is ready to be plugged in.
Fig 1
Fig 2
9
GB