Set Up Instructions - Aqua One Nautilus 600 Aufbauanleitungen

Set Up Instructions

Filling with Media
1. Open the filter unit by releasing the 4 clips located
on the corners of the filter, then lift the head unit off the
canister body. Fig 1
2. Remove the filter grid and the filter media baskets
from the canister, remove all media from the plastic
bags and place it back into its basket according to the
media set up illustrated on page 4. Rinse the baskets
with the media in tap water to remove excess dust.
Fig 2
3. Replace the filter baskets in the filter following the
order shown on page 3. Ensure the filter baskets are
sitting flat on top of each other. Ensure the filter grid is
placed back on top of the last filter basket. This is very
important.
Checking the function
4. Prior to installing the head unit, connect it to the power
supply. You should be able to see the impeller spin. If
there are any problems refer to the Trouble Shooting
Section. Disconnect from the power supply after a few
seconds to avoid damaging the powerhead.
Replacing the head unit
5. Line the filter inlet pipe up with the feeder pipe on the
base of the head unit.
6. Press down gently, the bottom of the head unit should
be flush with the canister body. Be careful not to jam
the power cord in between the canister and the head
unit. Do not force it together! If it feels tight do not apply
Fig 1
any pressure to close it. Simply, remove the head unit
and filter baskets and try again.
7. Latch and secure the clips. The filter unit is now
ready to be installed.
Installing the tap connectors and
hose pipes
8. You will need the set of taps and two pieces of hose.
Screw the collar on the taps all the way in clockwise.
9. Now push one end of the hose over the hose tail
and thread. Push it on as far as possible. Then turn the
collar anti clockwise to lock in the hose. Repeat for the
other hose.
Fig 2
7
GB