Adler europe AD 7916 Bedienungsanweisung Seite 6

DEVICE DESCRIPTION (pictures A and B)
1. Control panel
3. Signal receptor
5. Transport handle
7. Evaporator inlet
9. Down cooler drain hole
11. Connector of air exhaust duct
CONTROL PANEL (picture C)
A. Power button ON/OFF
C. Mode button
E. Timer / Temperature down button
G. High speed lamp
I. Sleep button and child lock
K. Cool mode
M. Fan mode
O. Oscillation button
REMOTE CONTROLLER – picture D
The remote controller transmits signals to the system.
Button "A" - the appliance will be started when it is energized or will be stopped when it is in operation, if you press this button.
Button "C" - press it to select operation mode: "J", "K", "L" or "M".
Button "B" - press it to select fan speed in sequence.
Button "D" / "E" - press to adjust the room temperature and the timer.
Button "I" - press to set or cancel sleep mode.
Button "N" - press to set the time of automatic off and automatic on.
Button "O" - press to set or cancel louvers swing mode.
OPERATION OF THE CONTROL PANEL
AUTOMATIC / COOL / DRY / FAN
1. Turn on the device.
a) Connect the device.
b) Press the "A" button, then the device beeps once and turn on.
c) LED diode displays room temperature and starts working in automatic mode.
2.Choose the operating mode
Press the "C" button to select the desired mode of operation by sequence:
Automatic mode "J" -> Cooling mode "K" -> Drying mode "L" -> Fan mode "M"
3. Adjust temperature
The temperature can be set within a range 15°-31°C. Press "D" or "E" button to increase or decrease the temperature by 1°C by pressing
once. The device LED panel shows the target temperature for 5 seconds and then displays the room temperature.
4. Adjust fan speed
Press the button "B" to select a desired fan speed shows by sequence:
Low speed "F" -> High speed G
5. Power
When you press the "A" button again, the device will sound "di" and stop working.
2. Cold air outlet
4. Remote controller
6. Exhaust duct
8. Upper cooler drain hole
10. Air exhaust duct
12. Window exhaust adapter
B. Fan speed button
D. Timer / Temperature up button
F. Low speed lamp
J. Automatic mode
L. Dry mode
N. Timer button
6