SYLCO ECO 560 Bedienungsanleitung Seite 19

To reset an anomaly, remove its cause, wait for 10 seconds, give an input to terminal 3 or 5.
Installation: when supplied, the sounder is in stand-by condition until input 3 "sounder control" is put
to 12V or 0V once. This is aimed to avoid sounder operating during installation.
Attention: If battery is out of charge (voltage lower than 10,5V), in case of alarm, the sounder operates
for 5 seconds only, in order to avoid a deeper discharge. Vice versa, the fl ash keeps on working regularly
and quickly (anomaly) and showing alarm or ON/OFF.
If battery voltage goes lower than 9,5V, both sounder and fl ash do not operate in order to avoid a deeper
discharge of the battery.
When fl ash is active during anomalies, it operates quickly.
Maintenance: It is suggested to disconnect also the recharge (terminal 2) during battery replacement
in order to immediately start a complete test of the sounder.
30 seconds after supplying the microcontroller tests the battery, then the test is repeated every 2 hours.
If during fi rst 30 seconds an alarm is triggered off, the battery anomaly indication remains on until
following test which will take place after 2 hours.
WARRANTY: All Sylco products are guaranteed for manufacturing or material defects. With the aim of
improving design and quality of its products, Sylco retains the right to modify the products without any
warning. All defective or failed products have to be returned to the own supplier.
Certifi cation for Belgium
Complying wih T014 Standards
Hereby the manufacturer declares that this product is in compliance with all relevant EU Directives on CE
marking and with 2014/30/EU Directive (Electromagnetic Compatibility Directive)
The full declaration of conformity is available upon request at info@sylco.com
SYLCO Società Uninominale srl - Via del Lavoro, 14 - 30030 Salzano (VE)
Tel. (+39) 041 5740327 - Fax (+39) 041 574415 - Web: www.sylco.com - E-mail: info@sylco.com
MADE IN ITALY
19
the sound of security