SYLCO ECO 560 Bedienungsanleitung Seite 18

CHART 4: SOUNDER INPUT POLARITY
DIP 2
ON
(default)
Not connected or 0V (Positive missing)
OFF
Not connected or +12V (Negative missing)
CHART 6: ON/OFF CONTROL PANEL INDICATION
DIP 4
ON
(default)
Not connected or 0V
OFF
Not connected or 0V
CHART 7: SOUNDER AND FLASH ACTIVATION
DIP 5
ON (default)
OFF
ON
OFF
CHART 8: MAX NUMBER OF ALARMS
DIP 7
Infinite alarms
ON (default)
Limitation to 4 daily (24 hours) alarms of sounder activation (T.5 resets the counter)
OFF
CHART 9: SOUNDER TONES
DIP 8
Increasing-Continuous-Decreasing
ON (default)
Increasing-Decreasing (NFC 48-265)
OFF
CHART 10: ANOMALIES
Speaker interruption (check every 10s)
Missing recharge current (V recharge < 12V) (check every 10s)
Battery not connected (check every 12 hours)
Battery low voltage (V battery < 10,5V) (check every 10s)
Faulty Battery– Internal resistor higher than 2,5 Ohm (check every 12 hours)
No Anomaly
TERMINAL 3
+12V
0V
TERMINAL 5
+12V
+12V
DIP 6 SOUNDER CONDITION
Controlled by Terminal 3
ON (default)
Controlled by Terminal 3
ON
Controlled by Terminal 3
OFF
Controlled by Terminal 3
OFF
NUMBER OF ALARMS DURING 24 HOURS AFTER FIRST ALARM
SOUND
ANOMALIES
CHART 5: FLASH INPUT POLARITY
SOUNDER STATE
DIP 3
Silence
(default)
Alarm
Silence
OFF
Alarm
FLASH CONDITION (ON/OFF)
All LEDs flash 3 times
All LEDs stay on for 4 seconds then switch off
All LEDs flash 3 times and one LED keeps on flashing
All LEDs stay on for 4 seconds and then switch off
T.4 Arms - T.3 Starts - T.4 Disarms and stops.
Starts with T.3 and Stops with 1 pulse to Reset
Starts with T.4 and stops with T.4 (independent)
FREQUENCY LIMITS (Hz)
1.200 - 1.750
1.400 - 1.600
18
TERMINAL 4
0V or not connected
ON
12V
12V or not connected
0V
FLASH CONDITION
flash T.4
Controlled by Terminal 3
dB (A) at 1m
116
115
RED LED LD7
1 FLASH
2 FLASHES
3 FLASHES
4 FLASHES
5 FLASHES
OFF
FLASH
CONDITION
Flashing
blocked
Flashing
blocked
OUTPUT T.6
0V
0V
0V
0V
0V
OPEN