Siemens LI 46630 Gebrauchsanleitung Und Montageanleitung Seite 25

Preparing the wall cupboard
This extractor hood is designed to be
installed in a wall cupboard with the follo-
wing dimensions:
width: 600 mm
depth: 293 to 350 mm
height: min. 435 mm.
If the cupboard is deeper than 293 mm,
the extractor hood can be moved back,
e.g. to put a spice rack in front of the
extractor hood.
To do this, place the template
back.
Ensure that the cupboard is stable both
during and after installation, even if fitted at
the end of a row of kitchen units.
1. Mark two attachment points on both the
O
further
II
2. Screw on both attachment plates
3. Attach the door to the cupboard and
right and left inside faces of the cup-
board and make holes with a bradawl.
When you drill:
2 mm diameter – max. 10 mm in depth.
Use the enclosed template
the attachment points.
align.
Observe the minimum distance
between hotplates and extractor hood!
Fig. 1.
O
to mark
II
25