Status Information - Nannio FollowMe Bedienungsanleitung

1. If you want to add a new camera, please choose which number of cameras
you want to add, and then select add camera icon
to confirm your selection (See Fig. 16).
The screen will show
please also press and hold the power button around 3 seconds on the camera
side at the same time.
2. If you want to delete a paired camera, please choose which number of cameras
you want to delete, and then select delete camera icon
(See Fig. 16).
3
.5 Brightness Setting ( Brightness )
In this submenu you can adjust brightness of the screen (See Fig. 17).
3
.6 VOX Sensitivity Setting ( VOX Sensitivity )
This submenu lets you choose the VOX (voice activation) sensitivity level.
When the level set to high, the screen will turn on by lower sounds.
(See Fig. 18).
3
.7 Auto Tracking Setting ( Auto Tracking )
In the submenu you can select
"Off " to disable it. When auto tracking is enabled, the camera will track moving
objects in the camera viewing range. Please (see Fig. 19).
Note 1: The audio will be muted when motor rotates.
Note 2: When the zoom in function is enabled, auto tracking will be disabled
4

Status Information

The status bar will be displayed on the top of the screen (See Fig. 20).
1. Signal strength indicator
2. Camera number indicator
3. Temperature alert on/off indicator
4. Room temperature indicator
5. Zoom in indicator
6. Feed timer indicator
7. Auto tracking indicator
8. Talkback indicator
9. Auto-scan indicator
10. Battery status/Charging indicator
11. Music indicator
"Press the pairing button on the Baby unit" , and then


until the user zooms out.
"On" to enable the auto tracking function or select


and press the button
to delete the camera


5