Vitek VT-1752 BK Betriebsanweisung Seite 4

ENGLISH
•
Do not use the power cord for carrying the unit.
•
Do not wind the power cord around the unit
body.
• Avoid contact of the power cord with hot and
sharp subjects.
•
If foreign smell or noise appears, stop using
the unit immediately.
• Do not switch on the unit if the power cord or
the plug is damaged, if the unit malfunctions
or in case the unit fell. In this case contact
the authorized service center for checking or
repairing the unit.
• For children safety do not leave polyethylene
bags, used as a packaging, unattended.
Attention! Do not allow children to play with
polyethylene bags or packaging film. Danger
of suffocation!
•
Do not allow children to use the unit as a toy.
•
Be especially careful if children or disabled
persons use the unit.
• This unit is not intended for usage by children
or disabled persons unless they are given all
the necessary instructions by a person who
is responsible for their safety on safety mea-
sures and information about danger that can
be caused by improper usage of the unit.
THE UNIT IS INTENDED FOR HOUSEHOLD
USAGE ONLY
Usage
•
Place the fan heater on a flat and steady sur-
face so that the air inlets of the fan heater will
not be blocked by foreign objects.
ATTENTION: Provide that no other electrical
appliances with higher power consumption
are connected to the same outlet the fan
heater is connected to.
•
Insert the power cord (8) plug into the sock-
et, you will hear three sound signals, and
the icons on the display (3) will light up for a
short time.
Note: Every pressing of the control panel (4)
buttons is accompanied by two sound signals.
• Touch the On/Off button (11) to switch on
the unit, you'll hear two sound signals, and
the fan heater will switch to the previously
set mode.
• Pressing the button (14) choose the neces-
sary operation mode, the operation modes
are shown by icons on the display (3):
VT-1752.indd 4
Air room low heating level
–
Air room medium heating level
–
Air room
–
«ECO» mode (15)
–
«Fan» mode (16)
–
«Anti-freeze» freezing prevention mode
–
(19)
• In «ECO» mode you can set the air tempera-
ture that the unit will maintain in the room
when operating. Switch on the unit by press-
ing the button (11) and pressing the button
(14), choose «ECO» mode, icons (15) and
(18) will light up on the display, and the room
air temperature will be shown. Pressing but-
tons (13) «+» «-» you can set necessary room
air temperature from +16оС to +32оС. When
the air temperature in the room decreases
for about 3 degrees, the unit will switch on
automatically into the air heating mode, in
case of exceeding the set air temperature by
about 3 degrees the unit will switch off.
•
To ventilate the room, choose the «Fan»
mode « » by pressing operating mode
selection button (14), the icon (16) will light
up on the display (3). In this mode the room
is not heated.
•
The unit has "Anti-freeze" mode, which
switches on at significant decrease of air
temperature in the room. Pressing the oper-
ating mode selection button (14), choose the
«Anti-freeze» mode, the icons (18, 19) will
light up on the display and the preset tem-
perature of automatic unit switch-on +7оС
will be shown. The fan heater will switch on
automatically if the air temperature in the
room is below +7°С.
Note: Before choosing the «Anti-freeze» mode,
set the necessary operation mode, for example,
air heating or ventilation, see the description of
operation modes above.
•
To switch on the fan heater oscillation func-
tion while operating, press the button (10),
to switch off this function press the button
(10) again.
•
You can set the operation time using the
timer, while the unit is operating. Press but-
ton (12) to switch on the timer function,
the icon (17) will light up on the display (3).
Pressing the buttons (13) «+» «-» set the
4
high heating level
05.06.2012 11:11:59