Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
10.
Depress the positive/red push terminal on the back of the
speaker and insert the bare wire lead or pin plug on the positive
lead into the hole on the side of the terminal. Release the
terminal.
11.
Depress the negative/black push terminal and insert the bare wire
lead or pin plug on the negative lead into the hole on the side of
the terminal; then release the terminal. Gently pull on each lead to
ensure that they are securely connected to the terminals.
12.
Rotate the Tap Selector so that the correct power setting is
selected (see side image).
13.
Ensure that the mounting tabs on the speaker assembly are turned inward.
14.
Begin to insert speaker into the cutout hole. When the speaker is flush with
the wall/ceiling leaving only the black magnetic brim exposed, use a #2
Phillips screwdriver to begin to tighten the 6 attachment screws which are
connected to the mounting tabs (see side images). The screws will
automatically turn once you begin rotating the screw clockwise. Repeat for all
6 tabs and make sure not to overtighten the screws.
15.
Replace the grille onto the speaker body.
16.
Ensure that your amplifier is powered off and unplugged from the power
source.
17.
Connect the amplifier end of the speaker wire to one of the speaker level
outputs on your amplifier, taking care to match the polarity markings on the
speaker wire or plugs.
18.
Enjoy using the DN-205W!
High-Frequency Roll-Off
DN-205W is equipped with a high-frequency roll-off option, which can be used to attenuate the high-
frequency response. If the speaker sounds too "bright", perform the following steps to set the high-
frequency roll-off.
1.
Pull the edge of the grille to remove it.
2.
Adjust the high-frequency roll-off switch to the -3 dB or -6 dB position. The default setting is 0 dB (no
attenuation).
3.
Replace the grille onto the speaker body.
6
Werbung
Inhaltsverzeichnis
