Vitek VT-4225 CA Betriebsanweisung Seite 9

TROUBLES AND TROUBLESHOOTING
Failure
The multicooker lid (8)
can't be closed.
The pressure in the
multicooker has been
released, but the lid (8)
can not be opened.
Steam is released from
under the lid (8) during
cooking.
Air comes out through the
blocking system valve (9).
The blocking system valve
(9) does not go up.
Guarantee
Details regarding guarantee conditions can be
obtained from the dealer from whom the appli-
ance was purchased. The bill of sale or receipt
must be produced when making any claim under
the terms of this guarantee.
VT-4225.indd 9
Possible Cause
The silicone gasket or protection
screen (7) is installed improperly.
The blocking system valve (9) is
blocked in the upper position.
The blocking system valve (9) has
not moved to the lower position.
The silicone gasket is not installed
on the protection screen (7).
The silicone gasket is very dirty.
The silicone gasket is damaged.
The lid (8) is not closed tightly.
The valve (9) is dirty.
The silicone ring of the blocking
system valve (9) is damaged.
The pressure control valve (11) is
installed improperly.
Not enough ingredients or liquid for
steam generation.
9
ENGLISH
Solution
Remove the protection screen
(7), check whether the silicone
gasket is installed properly.
Remove the object blocking the
valve (9).
Press the valve (9) and set it
down.
Switch off the unit, release the
pressure in the multicooker,
open the lid (8). Place the
silicone gasket on the protection
screen (7).
Clean the silicone gasket.
Replace the silicone gasket.
Close the lid (8) tightly.
Switch the multicooker off,
remove the lid (8) and clean the
valve (9).
Replace the silicone ring of the
valve (9).
Make sure that the valve is
installed properly.
Follow the recommendations for
amount of products and liquid in
the bowl (6).
This product conforms to the EMC-
Requirements as laid down by the Council
Directive 2004/108/ЕС and to the Low
Voltage Regulation (2006/95/ЕС)
26.08.2014 14:22:12