3M SCPFWMV2 Installationsanleitung Seite 6

4.2 Align the cables alongside the power cable and
secure using cable ties.
5.0 Solid Wall Installation
(For Concrete Block or Stud Walls, Skip to Step 7)
5.1 Determine desired size and location of projected
image and mark the location of the top and center of
the image.
5.2 Locate the "top of image" line of the template for
the desired image size and then align "top of image"
and "image center line" lines with the location of the
desired image size. Then mark the positions of the
template's four cross-hairs on the wall.
3M ™ Folding
Wall Mount
Mounting Template
For use with:
SCP715, SCP717,
SCP740
SCP715, SCP717
SCP740
5.3
Note: Use a 1/2" masonry drill bit for solid concrete
5.4
6.0
6.1
Image Area
6
3M ™ Folding Wall Mount SCPFWMV2 and SCPFWMSV2
Using the appropriate bit, drill 4 holes for the
mounting lag bolt anchors. Install the short anchors
in the upper holes, and the long anchors in the
lower holes.
walls or a 3/16" drill bit for wood walls. Do not use
anchors for wood walls, only use screws.
Using a 3/8" socket, install the 2 short (upper)
mounting lag bolts, leaving 1/2" (13 mm) of the
screw protruding from the wall. Do not install the
long (lower) lag bolts.
1/2"
(13 mm)
Attach to Wall
Hang the wall mount base on the mounting lag bolts.
Using a 3/8" socket, tighten the mounting lag bolts
securely.
© 2008 3M. All Rights Reserved.