Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ASSEMBLY
Dust filter:
Carefully place on the dust bin dust filter and foam filter on the suction cover
with motor.
Dust bin:
Attach the dust bin to the vacuum cleaner motor.
A flexible hose (optional):
If you use a hose, plug the end into the air inlet hole. Make sure that you
hear the sound as it clicks into place.
Accessories:
Choose the required accessory (brush or hose) and connect it to
the air inlet hole or hose.
USE
• Before you start, make sure that the dust and foam filters are place. Foam filter is mounted on
the suction basket on the underside of the lid with the motor.
• Before you start, make sure that assembled hose is in place correctly, as this could damage
the device.
• Unroll the power cord. (Length of 5 m)
• Nominal AC power outlet on the vacuum cleaner: ≤ 1 000 W. The socket is designed to
connect electrical workshop tools
• Plug the device into an outlet and turn it on.
• After use, unplug from the wall.
• Connect the necessary accessories to the vacuum cleaner.
• Switch on, so that the switch in on position I (on).
• To turn off switch to O (off).
• After use, always clean the vacuum cleaner.
• If during vacuum the unit starts to emit a different sound, it indicates that could be clogged.
Immediately in this case shut off and clean.
• Check the filter bag, container, hose and tube.
• Do not vacuum without foam filter.
VACUUMING OF LIQUIDS
In vacuum cleaner there is a float which closes the air flow when liquid reaches the maximum level.
Then, you have to immediately turn off the vacuum cleaner. Before vacuuming, always check that
the float inside of the suction basket and can move freely.
When vacuuming bigger quantity of clear or slightly murky water, remove the container from the filter
bag. When vacuuming strongly polluted water, leave the bag in the container.
This bag reduces the contents of the container.
To empty it completely, tilt the container forward.
14
str
Werbung
Inhaltsverzeichnis
