Specifications - DJI TAKYON Z14120 Kurzanleitung

3. When using the Takyon Z14120 together with the DJI N3 or A3 flight
controller, connect the data cable (JST 3-pin) to the iESC port on the
flight controller via a smart ESC communication cable for redundant
throttle signal transmission.
4. Connect the motor to the ESC.
System Status Beep Codes
You can instantly tell the system's status by observing the emitted
sounds from the motor.
Normal
Startup Tone
Abnormal
Rapid Beeping
Slow Beeping
Alternating Double and
Triple Beeps

Specifications

Max Allowable Voltage
Max Allowable Current* (Continuous)
Max Peak Current (< 3 sec)
Max Regular Signal Frequency
Defaulted Output PWM Frequency
Weight (Without Cables)
Battery
Operating Temperature
* Data measured in a ventilated environment and at a temperature of 25℃ .
© 2017 DJI All Rights Reserved.
6
Description
System ready.
Description
Starting input signal is not at minimum.
Check the settings of your flight controller, receiver
and remote controller.
No signal input.
Using the remote controller for configuration. Refer
to the User Manual for more details.
61 V
120 A
160 A
500 Hz
16 kHz
130 g
5S - 14S LiPo
14° to 104° F (-10° to 40° C)