Battery Replacement - DPM V30 Bedienungsanleitung

Detektor przewodów pod napięciem
3. Keeping the switch  pressed, slowly move the detector to the right and left on the wall. Avoid
lifting the device or changing the ground pressure while scanning. Do not tilt the device or make
circular movements while scanning.
4. Detection of wires is indicated by the blinking of the diode  and the sound signal. Mark this area
on the surface to be tested.
5. Move the detector until the diode  stops blinking and the acoustic signal turns off, which means
that the detector does not detect the wires.
Before scanning, remove metal jewelry from your hands and hands (watches, rings, bra-

celets)  During the measurement, the detector should be held with one hand and the
other hand should be kept more than 15 cm from the detector  It is recommended to
carry out the measurement several times in order to obtain the most precise result  If
the signal is weak or unstable, select a different measurement location  If the diode
blinks at every detection point, it may mean that there is an electrostatic phenomenon
on the detected surface, which makes it unsuitable for measurements. To discharge
the static charge, place your hand flat against the wall near the detector and repeat
the detection procedure  If the wires are placed horizontally, the measurement
should be carried out by moving the device up and down.
Description
 Detected live AC wire indicator
 LED indicator
 Sound indicator
 ON/OFF switch

Battery replacement

1. If the LED diode is weak or completely turns off during the measurement, check the batteries and
replace them if necessary.
2. Place new batteries (2 x AAA) paying attention to the correct polarity.
3. It is recommended to use alkaline batteries.
4. Used batteries as hazardous waste should be thrown into specially marked containers or handed
over to a separate collection point. Do not dispose of batteries in the trash bin.
5. Do not use new and used batteries at the same time.
 Hereby, DPMSolid Ltd SP. k. declares that live AC wires detector V30 is in compliance with
Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the
following internet address: http://www.dpm.eu
The detector is not a measuring instrument within the meaning of the Measures Act
6