Safety Instructions - DPM V30 Bedienungsanleitung

Safety instructions

1. User's manual is a part of the product and it should be stored with the device.
2. Before use read the user's manual and check the technical specification of the device and strictly
obey it.
3. Operating the unit contrary to the instruction manual and its purpose may cause damage to the unit,
fire, electric shock or other hazards to the user.
4. The manufacturer is not liable for any damages to persons or property caused by improper use,
contrary to its intended purpose, the technical specifications or the user's manual.
5. Before use check if the device or any of its components is not damaged. Do not use damaged
product.
6. Do not open, disassemble or modify the device. All repairs may only be made by an authorized
service center.
7. Use the device only in dry interior rooms. International Protection Rating for the device is IP20.
8. Do not use the detector immediately after it has been moved from cold to warm space. Wait until it
reaches room temperature.
9. The device should be protected against:
a. dropping and shaking
b. high and low temperatures
c. humidity, flooding and splashing
d. direct sunlight
e. chemicals
f. and other factors that could affect the device and its operation.
10. The device should be cleaned with a dry and soft cloth. Do not use abrasive powders, alcohol,
solvents, or other strong detergents.
11. Product is not a toy. The device and packaging must be kept out of the reach of children and animals.
Features
Detector indicates the location of live AC wires in walls, ceilings and floor  detection range: max.
40 mm  power supply: 2 x AAA (not included)  operating conditions: 0°C ~ +40°C  LED and sound
indicator  automatic calibration
Shielded cables, low-voltage signal cables (CAN, computer) and telephone wires

will not be detected by the detector  AC wires located deeper than the detector's
maximum range will not be detected  Live AC wires in metal pipes, metal walls or
metal-covered insulation will not be detected  Cables with DC current will not be
detected  Do not use the detector on wet, damp or covered with aluminum or metal
surface.
Detection
1. Place the detector perpendicular to the wall.
2. Press and hold the detector switch . LED turns on .
V30

5