cascade corporation H Series Installations Seite 13

P
ERIODIC MAINTENANCE
10H–18H Clamps
1000-Hour Maintenance
After each 1000 hours of truck operation, in addition to
the 100 and 500-hour maintenance, perform the following
procedures:
• Change rotator drive gearcase lubricant. Drain oil out
the case drain hole. Fill through the fill hole up to the
level hole. Use Cascade Rotator Drive Lubricant, Part
No. 656300, or SAE 90 wt. gear lube (AGMA 'mild' 6
EP Gear Oil). Replace plug.
2000-Hour Maintenance
After each 2000 hours of truck operation, in addition to
the 100, 500 and 1000-hour maintenance, perform the
following procedures:
• Check all rotation bearing capscrews for proper
torque value. See Technical Bulletin TB183, Service
Manual 6839447 (13H) or Service Manual 6805681
(18H) for inspection and replacement procedures.
• Inspect all arm and cylinder pivot pins for wear and
replace if necessary.
4000-Hour Maintenance
After each 4000 hours of truck operation, in addition to
the 100, 500 and 2000-hour maintenance, perform the
following procedures:
• Due to normal mechanical wear and component
service life, cylinder seals should be replaced to
maintain performance and safe operation.
6077316-R8 EN
Rotator Drive
Capscrews
Fill and
Level Hole
Lower Bolt-On Drain
Hook Capscrews Plug
Back (Driver's) Side
Level Hole
Access Hole for
Faceplate Rotation
Bearing Capscrews
Drain Plug
Baseplate
Rotation
Bearing
Capscrews
RC3625.eps
Lower Bolt-On
Hook Capscrews
13H & 18H
Back (Driver's) Side
Upper Hook
Capscrews
Access Hole
for Faceplate
Rotation Bearing
Capscrews
Baseplate
Rotation
Bearing
Capscrews
RC5140.eps
Lower Quick-Disconnect
Hook Capscrews
10H
Fill Hole
Rotator Drive
Capscrews
Upper Hook
Capscrews
Lower Quick-Disconnect
Hook Capscrews
11