Herunterladen Inhalt Inhalt Diese Seite drucken

Hifonics ZEUS ZRX12 BP Handbuch Seite 6

Single-bandpass-system
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

ENGLISH
LED-ILLUMINATION
The HiFONICS ZEUS ZRX subwoofer enclosures have an integrated LED-illumination. This illumi-
nation is only allowed to light up, if the vehicle is not in driving condition. It is recommended to switch
the illumination with the vehicle's trunk illumination.
POWER RATINGS
The HiFONICS ZEUS ZRX subwoofer enclosures are designed for high bass levels. Anyhow it is
possible, that unsatisfying sound characteristics could be caused by too low or too high amplifier
power. In certain circumstances this even can cause a damage to the loudspeakers.
It is recommended to choose rather a more powerful amplifier (ca. 15-20% more Watts RMS than
the max. RMS power rating of the woofer) and to use the amplifier not at the maximum output level
(low distortion factor, good sound characteristics). A weaker amplifier at the maximum level causes
worse sound characteristics due to the higher distortion factor.
Never crank up the output volume of your amplifier to the maximum level or run the amplifier into
the clipping range. If the sound is distorted and not clean, turn back the level until the distortions
disappear.
The HiFONICS ZEUS ZRX subwoofer enclosures have no integrated limiter or clipper, which is
limiting the level upwards. Overamplified bass peaks leads inevitably to a burn out of the voice coil
of the woofer. A burn out of the voice coil, caused by clipping/overamping is not covered by the
usual warranty.
Recommended power ratings:
• 1 x stereo-amplifier with 2 x 175 - 600 Watts RMS (Sinus) into 4 Ohms
• 1 x mono-amplifier with 350 - 600 Watts RMS into 2 Ohms
Please refer to the minimum impedance of the installed amplifier. In case of doubt ask your special-
ist dealer.
Please also refer to the interconnection examples on the next page.
6
For the + 12V power supply of LED-illumination, use
the attached cable at the right terminal and connect
it accordingly. Please ensure the correct polarity as
marked.
NOTE: Do not use the speaker cables as power supply
for the LED-illumination.

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Zeus zrx12 bpl

Inhaltsverzeichnis