Parts Replacement; Warranty - Felisatti TP517/AS Bedienungsanleitung

PARTS REPLACEMENT

WARNING!
Disconnect the plug from the power supply socket before
replacing any parts.
BRUSHES
The brushes must be replaced after approx. 150-200 working
hours, or if they are less then 5-6 mm in length.
WARNING!
For correct tool operation always change the brushes in
pairs, not separately. The use of original Felisatti spare parts
is recommended.
WARNING!
This operation should only be performed by anauthorized
service center.
WARNING!: After fitting new brushes allow the motor to run
idle for 5 minutes.
REPLACING THE POWER SUPPLY CABLE
Check that the power supply cable is in good condition, if not
have it replaced by an authorized service center.

WARRANTY

See general warranty conditions printed on the attached sheet.
DISPOSAL
The machine, accessories and packaging should be sorted
for environmental-friendly recycling.
Do not dispose of power tools into household waste!
According the European Guideline 2002/96/EC
for Waste Electrical and Electronic Equipment and its
implementation into national right, power tools that are no
longer usable must be collected separately and disposed of
in an environmentally correct manner.
8