Technical Data - Sauber PAC-123584 Gebrauchsanleitung

The hot air exhaust hose is not connected
or blocked.
Temperature setting is too high.
Air inlet is blocked.
The ground is not level or not flat enough.
Noisy
The sound comes from the flowing of the
refrigerant inside the appliance.
E0 Code Room temperature sensor failed.
E1 Code Condenser temperature sensor failed.
E2 Code Water tank full when cooling.
E3 Code Evaporator temperature sensor failed.

TECHNICAL DATA

Notice: Operation temperature range:
Dry bulb temperature /
Wet bulb temperature(℃)
Below data for your operating reference
Model
Rated voltage
Rated frequency
Rated input
Rated current
Cooling capacity
Moisture removal (L/H)
Air flow
ERP INFORMATION
Trademark
Model identification
Sound power (cooling)
Name of refrigerant
Rated power input for cooling (kW)
Rated energy efficiency ratio
GWP (kgCO eq)
2
Energy efficiency class
Maximum cooling Minimum cooling
35/24 18/12
PAC-123584
220-240V
50Hz
880W
4.0A
2300W (8000Btu/h)
0.9
320m³/h
Connect or clean the hot air exhaust
hose.
Reset the temperature.
Clean the air inlet.
Place the appliance on a flat, level
surface if possible.
It is normal.
Replace the room temperature sensor.
Contact authorized service technician
for repair.
Replace condenser temperature sensor.
Contact authorized service technician
for repair.
Take off the rubber stopper and empty
the water.
Replace evaporator temperature sensor.
Contact authorized service technician
for repair.
Value
Sauber
PAC-123584
≦65dB(A)
R290 (0.15kg)
0.883
2.6
3
A
- 28 -