Operation; Starting Up; Loading Cabinet - Norpe NorCon Gebrauchsanweisung

PI
Check the voltage and size of the fuse required on the rating plate attached to the cabinet. The
supply socket must be earthed and protected by a 10 A slow fuse. No other appliances may be
connected to the same fuse.
NOTE All electrical connections must be carried out by approved and qualified personnel
and comply with all IEE and local regulations, failure to do this could result in
personal or fatal injury.

4. Operation

The cooling is achieved by a fan evaporator system. The evaporator is located at the bottom of
the cabinet's tray. The cold air is blown to the shelves through the perforated back wall and
through the cooling cell in the top corner.
The cabinet is equipped with a Dixell XR40CX or NRC-100 controller.
In case the pressure rises to high, for example because of dirt in the condenser, the Dixell XR40CX
controller stops the machine from running and shows an error message (HA2).
NRC-100 controller turns off the cabinet's lights in case the pressure rises. See figure
1 on the inside cover for the location of the cabinet's light switch.
For more information on the different control systems, please see the corresponding
chapters.

4.1. Starting up

1. Connect the plug to the supply socket.
The compressor and fans start operating.
2. Wait for 90 minutes or until the desired temperature is reached.
The cabinet is now ready to be filled.

4.2. Loading cabinet

• Position the products carefully.
• Do not exceed the load limit. The maximum load on the shelves is 100 kg
per metre.
• Do not place products so that they protrude over the front edge of the shelf
or obstruct the inlet grid.
An unobstructed space of at least 20 mm must be left between the shelves
and the top plate of the cabinet. Products must not be placed in front of
the inlet and outlet grids and must not protrude over the front edges of the
shelves. Improper loading of the cabinet will disrupt the air flow and raise
the temperature of products in the cabinet.
See figures 2 and 3 on the inside cover.
• Do not place goods on top of the cabinet.
Version 5/2011
ENGLISH
6