Clutch Shift Series Anleitung Seite 5

02
Assembly Instructions - Chair Assembly
5. Install the plastic side covers using the Phillips
screw driver head on the allen key provided. Be
sure not to over tighten as you may crack the
plastic cover.
5
6. Remove the 4 M8 bolts already installed on the
underside of the seat pan. Position the mechanism
to align with those same holes and reinstall the bolts.
Again, be sure to start the bolts using your fingers to
ensure they are not cross threaded. Proceed by firmly
tightening the bolts with the allen key provided.
4 X M8
Important Note: Ensure that the mechanisn is orientated
correctly, front to back, as per the diagram above.
01
Assembly Instructions - Chair Assembly
7. Connect the upper portion of the chair
to the base by inserting the gas lift into
the corresponding hole in the mechansim.
Keep the upper part of the chair as vertical
as possible to ensure the gas lift seats
properly into the mechanism.
Congratulations!
You've just completed
assembly of your new
Clutch Chair.
English
6