Clutch Shift Series Anleitung Seite 4

02
Assembly Instructions - Chair Assembly
1. Place the base upside down on a firm but padded surface.
We recommend placing a piece of foam from the box on the floor.
Firmly insert the 5 castors into
the corresponding holes.
2. Turn the base right
side up and insert the
colour accent chevrons
in the end of each arm
of the base.
3
3. Insert the faux bolts
into the holes in the
center hub of the base.
5 X
4. Insert the thick
end of the gas lift
into the center
hole of the base
and slide the plastic
cover into place.
01
Assembly Instructions - Chair Assembly
4. Remove the 4 M8 bolts that are already installed on each side of the backrest. Then position
the backrest between the hinges that are attached to the seat pan. Reinstall the 4 M8 bolts into
their original holes once the hinges are in place. Be sure to use your fingers to start the bolts and
be careful to ensure they are not cross threaded. Proceed by firmly tightening the bolts with the
allen key provided.
4 X
English
M8
M8
4