LG CRD-8160B Bedienungshandbuch Seite 10

WHEN USING A SECONDARY CONTROLLER
* If your PC has an additional IDE controller on the motherboard or on a system slot, each
IDE device connected to the secondary IDE controller must also be set to the Master or
Slave mode. If you are connecting your CD-ROM drive to a secondary IDE card, and it is
the 1st device you are connecting to it, then set the CD-ROM jumper to the Master
position. If it is the 2nd device, set the CD-ROM jumper to the Slave position.
* Depending on the IDE card and whether the CD-ROM drive is a master or slave unit,
the diagram below represents the different ways in which the CD-ROM may be
configured in your PC. The table below the diagram shows the possible Jumper
placements that would correspond to each of the different configurations shown.
Secondary IDE
Controller CARD
Secondary IDE Channel
Secondary Slave
Secondary Master
(Hard Disk or
CD-ROM Drive)
CD-ROM Drive)
If you have the system with two IDE channels (in the case of an enhanced IDE PC),
do not install an IDE controller card in your system.
IDE Controller
Primary (1st IDE card)
Secondary (2nd IDE card)
Secondary (2nd IDE card)
PC Manual says use CSEL
Hard Disk Controller Card
(This card may be a connector on the Motherboard)
(Hard Disk or
Figure 5. Possible System Configuration
CD-ROM Connection
Slave(Hard disk is Master)
Master(1st device on 2nd IDE Card)
Slave(2nd device on 2nd IDE Card)
Card Slot
Motherboard
E-10
Primary IDE Channel
Primary Slave Primary Master
(Hard Disk or (Hard Disk for
CD-ROM Drive)
Jumper Placement
SLAVE (default)
MASTER
SLAVE (default)
CSEL
Boot-up)