Technical Details; Installation - Lampa Setay S4 Bedienungsanleitung

GB
PARKING SENSOR SYSTEM
1 Sensor
2 Digital display and audible
warning signal
3 Control box

TECHNICAL DETAILS:

• During reverse motion, sensors start signalling the presence of obstacles or pedestrians starting
from 150 cm distance.
• The distance from the obstacle is shown on the 3-colour-LED-display with a 7-steps-sequence to indicate
the changing distance from the obstacle both from right and left side of the car.
A multi-toned sound signal warns about the presence of an obstacle.
• Voltage: 12 Volt.
• Use temperature: -40°C / + 80°C
• Absorption: 4W (max)

INSTALLATION:

We warmly recommend to connect all the components and test the electric compatibility BEFORE
installing the parking sensors on the vehicle. Carry out a check both with the engine off and on.
In case of problems, please write to: service@lampa.it
1 Place the sensors between 50 and 80 cm from the ground
to grant a correct working. Minimum distance between the
sensors should be not less than 30 cm and not more than 80
cm. We recommend to keep the same distance between the
sensors in order to enable a perfect functioning of the device.
2 Use a measuring tape and an erasable marker to mark the po-
sition of the first sensor at 10-12 cm of distance from the right
corner of the rear bumper. Repeat the same operation with the
left corner.
3 Measure the distance between the two side sensors and divide
it by three to find out the location for the two central sensors.
Example: if the length between the side sensors is 180 cm, the
distance of the two central sensors must be 60 cm (180:3=60 cm).
4 Mount the drill (included in the mounting kit) on a wrench and
drill into the four points previously marked on the rear bumper.
5 Control unit must be placed inside the vehicle, to protect it
from heat, wet and water sprinkles.
6 The display must be placed in a suitable position on the
dashboard for a perfect visibility and audibility.
2
1
3
50~80
cm
L
1
3
1
1
1
L L
1 1
3 3
L