Troubleshooting - Lampa Setay S4 Bedienungsanleitung

GB
CONNECTING:
Control
Box
Red
Black
Reversing
tail light

TROUBLESHOOTING:

1 After the installation the display doesn't work:
• Are all wires connected properly?
• Is the vehicle ACC ON?
• Is the reversing gear engaged (the reversing light should turn on);
2 Damaged sensor detected:
• Are all sensors plugged into the ECU correctly and tightly?
• Is the sensor wire broken?
• Is the sensor covered by mud or snow?
• Is the sensor damaged?
3 False warning:
• Are all sensors plugged into the ECU in the correct position tightly?
• Does any sensor detect the ground?
4 When the reversing gear is engaged, the display always shows 0.5m or 0.6m:
• Is the sensor mounting too low or facing to the ground?
• Is sensor mounted upside-down?
If the problem persists contact your dealer or write us at: service@lampa.it or call our offi ce:
+39 0375 820700. We will gladly help you.
Display and Horn
1 Identify and verify polarity of the
original wiring of the reversing lights.
2 Connect the BLACK wire to the
negative (-) pole.
3 Connect the RED wire to the positive (+)
Sensor A
Sensor B
Sensor C
Sensor D