Rear Panel - Denon PROFESSIONAL DN-900R Schnellstartanleitung

Rear Panel

1
1. Analog Input, Balanced XLR: Use standard XLR cables to connect these inputs to your
sound souce, such a microphone.
2. Analog Input, Unbalanced RCA: Use standard RCA stereo cables to connect these inputs
to your sound source, such as a CD player.
3. Digital Input, Digital XLR: Use a digital XLR cable (IEC60958 Type I, AES/EBU) to connect
this input to your sound source.
4. Digital Input, Digital RCA: Use digital RCA cables (IEC60958 Type II, S/PDIF coaxial) to
connect this input to your sound source.
5. Analog Output, Balanced XLR: Use standard XLR cables to connect these outputs to
external speakers, a sound system, etc.
6. Analog Output, Unbalanced RCA: Use standard RCA stereo cables to connect these
outputs to external speakers, a sound system, etc.
7. Digital Output, Digital XLR: Use a digital XLR cable (IEC60958 Type I, AES/EBU) to
connect this output to your sound system.
8. Digital Output, Digital RCA: Use digital coaxial RCA cables (IEC60958 Type II, S/PDIF
coaxial) to connect this output to your sound system.
9. LAN Port: Use a standard Ethernet cable (IEEE 802.3u (3.3V I/O) / 10/100 Base-T(X) / RJ-45)
to connect this port to a network switch or router.
10. Dante Port: Use a standard Ethernet cable to connect DN-900R to a Dante network from
this port. Dante channel routing is set using the Dante Control software, available for
download at audinate.com/products/software/dante-controller.
11. RS-232C Terminal: Use a 9-pin D-sub connector to connect a host device such as a
computer to DN-900R to control it using serial commands.
Note: Visit denonpro.com
12. AC Input: Use the included power cable to connect this input to a power outlet.
2 3
4 5
to download the Serial Protocol Guide for more information.
6 9 10
7 8
12
11
9